Starting the VM

Login

Once the VM is up and running you can log into the shell console using:

• Username: root
• Password: maestro

Ports

The following services are running in the VM:

VMware

In VMware the VM can be accessed using its IP address, that can be obtained from the VM shell running:

$ ifconfig eth0

This will return:

[root@demo ~]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:0C:29:46:54:FC
          inet addr:172.16.223.139  Bcast:172.16.223.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fe46:54fc/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:84735 errors:0 dropped:0 overruns:0 frame:0
          TX packets:197059 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:12326998 (11.7 MiB)  TX bytes:261991746 (249.8 MiB)

In this case the Maestro interface can be accessed at http://172.16.223.139:8080/.  Be sure to adjust for your assigned IP address.

VirtualBox

The VM is configured to use NAT only network with port forwarding, by default forwarding ports from your localhost to the VM.

Click on VirtualBox Settings -> Network -> Adapter 1 -> Advanced -> Port Forwarding and ensure that at least port 8080, and any of the other ports if you wish, are forwarded from localhost to your VM. You can change the local port if any of them conflict with other services running in your host.

The Maestro interface can be accessed at http://localhost:8080/.